CNC Construction Set Volume 3B : Advanced Electrics

vol 3b cover products.jpg
vol 3b cover products.jpg

CNC Construction Set Volume 3B : Advanced Electrics

29.95 39.99

This is the third volume in the CNC Construction Set series. This volume shows you how to install and configure advanced electrics for your CNC Construction Set

Included with this volume is a detailed “Bill of Materials”. It contains a list of all components (with links) needed to complete this volume.

The Book:

  • Chapters: 18

  • Pages: 194

Volume 3B covers:

  • Installing the X, Y, and Z axis motors

  • Mach 3 configuration

  • Installing the UC300ETH motion controller

  • 5 volt and 12 volt regulator installation

  • Axis Tuning

Please note that the volumes 3 and 3B are the same volumes, this volume (3B) covers the more advanced UC300ETH motion controller, as well as the voltage regulators needed to support it. This is a more expensive and complex approach to the CNCCS electronics. If you plan on using your CNCCS for plasma cutting, it is possible with the UC100 but the UC300ETH gives you more options.

More Information

CNC Construction Set Introduction

Add To Cart